基于ANSYS-AQWA的垫挡船码头靠泊特性分析

doi:10.3969/j.issn.1674-0696.2023.03.11

重庆交通大学学报（自然科学版） ›› 2023, Vol. 42 ›› Issue (3): 78-83.DOI: 10.3969/j.issn.1674-0696.2023.03.11

• 交通基础设施工程 • 上一篇

基于ANSYS-AQWA的垫挡船码头靠泊特性分析

袁培银1，李渝锋1，赵宇2，张哲1

(1. 重庆交通大学航运与船舶工程学院，重庆 400074；2. 重庆交通大学建筑与城市规划学院，重庆 400074)

收稿日期:2021-03-19 修回日期:2021-11-23 发布日期:2023-05-11
作者简介:袁培银（1987—），男，黑龙江依安人，副教授，博士，主要从事船舶与海洋结构物方面的研究。E-mail：yuan_pei_yin@163.com
基金资助:
重庆市教委科研项目(KJZD-K202200703)

Characteristics of Cushion Ship Berthing at Dock Based on ANSYS-AQWA

YUAN Peiyin1, LI Yufeng1, ZHAO Yu2, ZHANG Zhe1

(1. School of Shipping and Naval Architecture, Chongqing Jiaotong University, Chongqing 400074, China; 2. College of Architecture and Urban Planning, Chongqing Jiaotong University, Chongqing 400074, China)

Received:2021-03-19 Revised:2021-11-23 Published:2023-05-11

摘要/Abstract

摘要： 船舶逐步向标准化、大型化的方向发展，有效减少或避免大型船舶对码头碰撞是工程领域亟待解决的问题。采用ANASYS-AQWA仿真软件，基于三维势流理论与时域分析方法，结合山区河流水流湍急、流量变幅大的特点，采用数值分析的方法，研究了船舶在不同系泊方式下的系泊运动响应特性。研究结果表明：0°和180°的浪向角对纵荡幅值响应算子的影响最明显；90°的浪向角对横荡、垂荡和横摇响应较大，对纵荡、纵摇和艏摇影响较小； 2-7-2系泊方式对于船舶的横向运动限制更好；4-4-4系泊对于船舶的纵向运动限制更好。

关键词: 船舶工程；三维势流理论；垫挡船；幅值响应算子；系泊特性；码头靠泊

Abstract: Ships are gradually developing in the direction of standardization and large scale. It is an urgent problem to be solved in the engineering field to effectively reduce or avoid the collision between large ships and wharves. Based on the three-dimensional potential flow theory and time-domain analysis method, and in combination with the characteristics of turbulent flow and large flow variation in mountainous rivers, the mooring motion response characteristics of ships under different mooring modes were studied by adopting the numerical analysis method and ANASYS-AQWA simulation software. The research results show that the wave direction angles of 0° and 180° have the most obvious effect on the amplitude response operator of surge, and the wave direction angle of 90° has a larger response to sway, heave and roll, and a smaller impact on surge, pitch and yaw. The 2-7-2 mooring mode has a better restriction on the lateral movement of ships, while the 4-4-4 mooring mode has a better restriction on the longitudinal movement of ships.

Key words: ship engineering; three-dimensional potential flow theory; cushion ship; amplitude response operator; mooring characteristics; wharf berthing

中图分类号:

袁培银1，李渝锋1，赵宇2，张哲1. 基于ANSYS-AQWA的垫挡船码头靠泊特性分析[J]. 重庆交通大学学报（自然科学版）, 2023, 42(3): 78-83.

YUAN Peiyin1, LI Yufeng1, ZHAO Yu2, ZHANG Zhe1. Characteristics of Cushion Ship Berthing at Dock Based on ANSYS-AQWA[J]. Journal of Chongqing Jiaotong University(Natural Science), 2023, 42(3): 78-83.

参考文献

［1］梅森.三峡库区及长江干线船舶经济航行优化研究［D］.大连：大连海事大学，2009.
MEI Sen.Study on Economic Navigation Optimization of Ships in the Three Gorges Reservoir Area and the Trunk Line of the Yangtze River［D］. Dalian: Dalian Maritime University, 2009.
［2］徐明洪.宁波港25万吨级原油中转码头撞击能量综合研究［D］.南京：河海大学，2004.
XU Minghong. Comprehensive Study on Impact Energy of 250 000-Ton Crude Oil Transit Terminal in Ningbo Port［D］. Nanjing: Hohai University, 2004.
［3］高峰，王炜正，李焱.大型LNG船舶在风浪流共同作用下的系泊试验研究［J］.水道港口，2013，34(5)：398-402.
GAO Feng, WANG Weizheng, LI Yan. Experimental study of mooring under combined action of wind, wave and current for large LNG ships［J］. Journal of Waterway and Harbor, 2013, 34(5): 398-402.
［4］胡毅，胡紫剑，刘元丹，等.基于AQWA的大型LNG船码头系泊分析［J］.舰船科学技术，2012，34(2)：70-73.
HU Yi, HU Zijian, LIU Yuandan, et al. Analysis of the large LNG ships moored against a quay based on AQWA［J］. Ship Science and Technology, 2012, 34(2): 70-73.
［5］周丰，张志明，杨国平，等.码头系泊船舶系缆力及运动量数值模拟［J］.中国港湾建设，2010(增刊1)：60-63.
ZHOU Feng, ZHANG Zhiming, YANG Guoping, et al. Numerical simulation on the mooring line forces and movements of a moored ship［J］. China Harbor Engineering, 2010(Sup1): 60-63.
［6］ GRANT R, HOLBOKE M J. Shallow water effects on low-frequency wave excitation of moored ship［C］∥Offshore Technology Conference. Houston, U. S. A., 2004.
［7］ TAN Huiming, CHEN Fumao, CHEN Jia. Model test on influence of berth length on LNG vessel mooring under wave-current-wind loads［J］. Journal of Coastal Research, 2018, 85(1): 1061-1065.
［8］ ROSA-SANTOS P, TAVEIRA-PINTO F, VELOSO-GOMES F. Experimental evaluation of the tension mooring effect on the response of moored ships［J］.Coastal Engineering, 2013, 10(3): 60-71.
［9］ TOUZON I, NAVA V, GAO Zhen, et al.Small scale experimental validation of a numerical model of the HarshLab2.0 floating platform coupled with a non-linear lumped mass catenary mooring system［J］. Ocean Engineering, 2020, 200(15): 1-19.
［10］ ZHU Feng, GENG Ying, MIAO Hui. Experimental and modelling study on the response of mooring container ships in port under medium to long period waves［J］. International Journal of Computer Applications in Technology, 2020, 62(4): 327-337.
［11］刘明维，李明龙，吴林键，等.船闸浮式系船柱受荷响应力学模型［J］.重庆交通大学学报(自然科学版)，2022，41(5)：127-132.
LIU Mingwei, LI Minglong, WU Linjian, et al. Mechanical model of load-bearing response of floating bollard of ship lock［J］. Journal of Chongqing Jiaotong University(Natural Science), 2022, 41(5): 127-132.
［12］张婧，邵龙，吴洵，等.张紧式系泊深水FPSO的动力特性及系泊布置方式研究［J］.重庆交通大学学报(自然科学版)，2018，37(4)：121-127.
ZHANG Jing, SHAO Long, WU Xun, et al. Dynamic characteristics and mooring layout of deep-water FPSO with taut mooring system［J］. Journal of Chongqing Jiaotong University(Natural Science), 2018, 37(4): 121-127.
［13］马泽坤.基于AQWA的FPSO拖航安全研究［D］.大连：大连海事大学，2018.
MA Zekun. Research on the Towing System Safety of FPSO Based on AQWA［D］. Dalian: Dalian Maritime University, 2018.
［14］李永超，杨启.台风状态下码头护舷受力与吸能特点分析［J］.武汉理工大学学报(交通科学与工程版)，2011，35(4)：743-747.
LI Yongchao, YANG Qi. Forces and energy absorption of the fenders under typhoon state［J］. Journal of Wuhan University of Technology(Transportation Science & Engineering), 2011, 35(4): 743-747.

基于ANSYS-AQWA的垫挡船码头靠泊特性分析

Characteristics of Cushion Ship Berthing at Dock Based on ANSYS-AQWA

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics