中文核心期刊
CSCD来源期刊
中国科技核心期刊
RCCSE中国核心学术期刊

Journal of Chongqing Jiaotong University(Natural Science) ›› 2020, Vol. 39 ›› Issue (12): 74-79.DOI: 10.3969/j.issn.1674-0696.2020.12.12

• Highway & Railway Engineering • Previous Articles     Next Articles

Sliding Resistance and Mechanical Properties of Two-Component Epoxy Resin Anti-skid Thin Layer

XIE Qun1, WANG Quanlei2,3, WANG Huoming2, XU Zhoucong2   

  1. (1. Jiangxi North Jiangxi Highway Survey and Design Institute, Jiujiang 332001, Jiangxi, China; 2. China Merchants Chongqing Communications Research & Design Institute Co., Ltd., Chongqing 400067, China; 3. School of Highway, Changan University, Xian 710064, Shaanxi, China)
  • Received:2019-09-05 Revised:2019-10-21 Online:2020-12-18 Published:2020-12-18
  • Supported by:
     

双组分环氧树脂抗滑薄层抗滑及力学性能研究

谢群1,王全磊2,3,王火明2,徐周聪2   

  1. (1. 江西省赣北公路勘察设计院,江西 九江 332001; 2. 招商局重庆交通科研设计院有限公司,重庆 400067; 3. 长安大学 公路学院,陕西 西安 710064)
  • 作者简介:谢群(1966—),男,江西赣州人,高级工程师,主要从事道路建材方面的研究。E-mail: wqlchd@163.com 通信作者:王全磊(1989—),男,山东聊城人,博士,主要从事道路建材方面的研究。E-mail: 903699805@qq.com
  • 基金资助:
    重庆市社会事业与民生保障科技创新专项项目(cstc2015shms-ztzx30004);国家自然科学基金项目(51508496)

Abstract: In order to study the anti-skid performance of two-component epoxy resin anti-skid thin layer, the accelerated loading test and mechanical test were combined to discuss the influence of different aggregate types on their anti-skid performance. SMA-10 and the modified emulsified asphalt micro-surfacing were selected as control group to carry out the accelerated loading test. The variation rule of BPN, TD and aggregate abrasion mass loss rate changing with time was analyzed, and the attenuation law of anti-skid performance was fitted and regressed by logarithmic formula. Through shear test and drawing test, the influence of different aggregate types and asphalt base surfaces on their mechanical properties was analyzed. The experimental results show that:the skid resistance of the two-component epoxy resin anti-skid thin layer is better than that of SMA-10 and the modified emulsified asphalt micro-surfacing;within 3 hours after the start of accelerated loading test,the attenuation speed of anti-skid performance is relatively fast, and the attenuation speed is slow in the later stage and trends to decrease slowly;the relationship of TD and BPN changing with wear time has a good correlation with logarithmic formula;the shear strength and bond strength between the anti-skid thin layer and the asphalt concrete base surface are relatively high, and the failure surfaces of the specimens occur inside the asphalt layer.

 

Key words: highway engineering, two-component epoxy resin anti-skid thin layer, accelerated loading test, anti-skid performance, shear strength, bond strength

摘要: 为研究双组分环氧树脂抗滑薄层的抗滑性能,采用加速加载试验与力学试验相结合的方法,重点探讨了不同集料类型对其抗滑性能的影响。选择SMA-10与改性乳化沥青微表处作为对照组,开展加速加载试验,分析了BPN值、TD值、集料磨耗质量损失率随磨耗时间变化的规律;采用对数公式对抗滑性能的衰减规律进行了拟合回归。通过剪切试验与拉拔试验,分析了不同集料类型与沥青层基面对其力学性能的影响。试验结果表明:双组分环氧树脂抗滑薄层的抗滑性能优于SMA-10与改性乳化沥青微表处;加速加载试验开始后3 h内,抗滑性能衰变速度较快,后期衰减速度较慢并呈缓慢降低趋势;TD值与BPN值随磨耗时间变化的关系与对数公式呈较好的相关性;抗滑薄层与沥青混凝土基面间的剪切强度与黏结强度较高,试件的破坏面均出现于沥青层内部。

关键词: 道路工程, 双组分环氧树脂抗滑薄层, 加速加载试验, 抗滑性能, 剪切强度, 黏结强度

CLC Number: