中文核心期刊
CSCD来源期刊
中国科技核心期刊
RCCSE中国核心学术期刊

Journal of Chongqing Jiaotong University(Natural Science) ›› 2015, Vol. 34 ›› Issue (2): 144-147.DOI: 10.3969/j.issn.1674-0696.2015.02.31

Previous Articles     Next Articles

Optimizing and Matching Analysis of Suspension Parameters of Van Truck Cab

Li Xiushan1, Zeng Falin1, Liu Hanguang2, Tang Chuanzheng1, Zhu Liangliang1   

  1. 1. School of Automobile and Traffic Engineering, Jiangsu University, Zhenjiang 212013, Jiangsu, China;2. Jiangsu Xuzhou Construction Machinery Research Institute, Xuzhou 221004, Jiangsu, China
  • Received:2013-03-31 Revised:2013-04-19 Online:2015-04-15 Published:2015-06-01

厢式运输车驾驶室悬置参数的优化与匹配分析

李秀山1,曾发林1,刘汉光2,唐传政1,朱亮亮1   

  1. 1. 江苏大学 汽车与交通工程学院,江苏 镇江,212013;2. 徐州工程机械研究院,江苏 徐州,221004
  • 作者简介:李秀山(1987-),男,山东德州人,硕士研究生,主要从事汽车CAE及平顺性方面的研究。E-mail:wsstudent163@163.com。

Abstract: Multi-body dynamics simulation model of van truck cab suspension was established by using multi-body dynamics software ADAMS. Appreciation of the cab floor acceleration RMS, combining the orthogonal design with ADAMS simulation, it researches on vibration isolation system parameters optimization and matching problem of the van truck cab suspension. On the B grade road, simulations at five different speeds were respectively calculated, and the optimization scheme of the original car cab suspension system parameters was put forward. The results of optimization show that the scheme can obviously improve the vehicle ride comfort and the effect of original vehicle vibration isolation.

Key words: vehicle engineering, cab suspension, multi-body dynamics, orthogonal experiment, parameter optimization, comfort

摘要: 利用多体动力学软件ADAMS建立厢式运输车驾驶室悬置多刚体动力学仿真模型,以驾驶室地板处加速度均方根值为评价对象,并且利用正交设计原理与ADAMS仿真技术相结合的方法,对原车驾驶室悬置隔振系统的参数优化与匹配问题进行研究。在B级路面上分别进行了5种车速下的仿真计算,并提出对原车驾驶室悬置系统参数的优化方案,优化结果表明该方案能够明显改善整车的行驶平顺性,解决了原车隔振效果差的问题。

关键词: 车辆工程, 驾驶室悬置, 多体动力学, 正交试验, 参数优化, 平顺性

CLC Number: