Optimizing and Matching Analysis of Suspension Parameters of Van Truck Cab

doi:10.3969/j.issn.1674-0696.2015.02.31

Journal of Chongqing Jiaotong University(Natural Science) ›› 2015, Vol. 34 ›› Issue (2): 144-147.DOI: 10.3969/j.issn.1674-0696.2015.02.31

Previous Articles Next Articles

Optimizing and Matching Analysis of Suspension Parameters of Van Truck Cab

Li Xiushan¹, Zeng Falin¹, Liu Hanguang², Tang Chuanzheng¹, Zhu Liangliang¹

1. School of Automobile and Traffic Engineering, Jiangsu University, Zhenjiang 212013, Jiangsu, China;2. Jiangsu Xuzhou Construction Machinery Research Institute, Xuzhou 221004, Jiangsu, China

Received:2013-03-31 Revised:2013-04-19 Online:2015-04-15 Published:2015-06-01

厢式运输车驾驶室悬置参数的优化与匹配分析

李秀山¹,曾发林¹,刘汉光²,唐传政¹,朱亮亮¹

1. 江苏大学汽车与交通工程学院，江苏镇江，212013;2. 徐州工程机械研究院，江苏徐州，221004

作者简介:李秀山(1987-)，男，山东德州人，硕士研究生，主要从事汽车CAE及平顺性方面的研究。E-mail:wsstudent163@163.com。

Abstract

Abstract: Multi-body dynamics simulation model of van truck cab suspension was established by using multi-body dynamics software ADAMS. Appreciation of the cab floor acceleration RMS, combining the orthogonal design with ADAMS simulation, it researches on vibration isolation system parameters optimization and matching problem of the van truck cab suspension. On the B grade road, simulations at five different speeds were respectively calculated, and the optimization scheme of the original car cab suspension system parameters was put forward. The results of optimization show that the scheme can obviously improve the vehicle ride comfort and the effect of original vehicle vibration isolation.

Key words: vehicle engineering, cab suspension, multi-body dynamics, orthogonal experiment, parameter optimization, comfort

摘要： 利用多体动力学软件ADAMS建立厢式运输车驾驶室悬置多刚体动力学仿真模型，以驾驶室地板处加速度均方根值为评价对象，并且利用正交设计原理与ADAMS仿真技术相结合的方法，对原车驾驶室悬置隔振系统的参数优化与匹配问题进行研究。在B级路面上分别进行了5种车速下的仿真计算，并提出对原车驾驶室悬置系统参数的优化方案，优化结果表明该方案能够明显改善整车的行驶平顺性，解决了原车隔振效果差的问题。

关键词: 车辆工程, 驾驶室悬置, 多体动力学, 正交试验, 参数优化, 平顺性

CLC Number:

U461.4

Li Xiushan, Zeng Falin, Liu Hanguang, Tang Chuanzheng, Zhu Liangliang. Optimizing and Matching Analysis of Suspension Parameters of Van Truck Cab[J]. Journal of Chongqing Jiaotong University(Natural Science), 2015, 34(2): 144-147.

李秀山,曾发林,刘汉光,唐传政,朱亮亮. 厢式运输车驾驶室悬置参数的优化与匹配分析[J]. 重庆交通大学学报（自然科学版）, 2015, 34(2): 144-147.

References

[1] Yeh E C,Kuo C Y,Sun P L.Conju-gate boundary method for control law design of anti-skid brake system[J].Vehicle Design,1990,11(1):40-61.
[2] Yeh E C,Day G C A,Parametric A.Study of anti-skid brake system using poincare map concept[J].Vehicle Design,1992,13(3):210-232.
[3] 程军.防抱制动系统防抱逻辑的研究[J].汽车工程,1995,17(1):1-11.
Cheng Jun.A study on the control logic of ABS[J].Automotive Engineering,1995,17(1):1-11.
[4]唐国元,宾鸿赞.ABS的模糊滑模变结构控制方法及仿真研究[J].中国机械工程,2007,18(13):1630-1633.
Tang Guoyuan,Bin Hongzan.Simulation study on fuzzy sliding mode control approach for ABS[J].China Mechanical Engineering,2007,18(13):1630-1633.
[5] 张孝祖.车辆控制理论基础及应用[M].北京：化学工业出版社,2007.
Zhang Xiaozu.Basis and Application of Vehicle Control[M].Beijing:Chemical Industry Press,2007.
[6] 王贵勇.汽车防抱制动系统(ABS)控制算法的研究[D].长春:吉林工业大学,2000.
Wang Guiyong.Research on the Control Algorithm of ABS[D].Changchun:Jilin University of Technology,2000.
[7] Drakunov S,Ozguner U,Dix P,et a1.ABS control using optimum search via sliding modes[J].IEEE Transactions on Control Systems Technology,1995,3(1):79-85.
[8] 赵治国,方宗德,傅卫平.防抱制动系统滑模状态观测和控制系统仿真[J].计算机仿真,2002,19(1):69-75.
Zhao Zhiguo,Fang Zongde,Fu Weiping.Research on sliding mode control for anti-lock braking system based state observability and wheel optimal slip estimation [J].Computer simulation,2002,19(1):69-75.
[9] 刘金琨.滑模变结构控制MATLAB仿真[M].北京:清华大学出版社,2012.
Liu Jinkun.The Sliding Mode Control and Its Simulation Using MATLAB[M].Beijing:Tsinghua University Press,2012.
[10]李果.车辆防抱死制动理论与应用[M].北京：国防工业出版社,2009.
Li Guo.Basis and Application of ABS[M].Beijing:National Defense Industry Press,2009.
[11]喻凡,林逸.汽车系统动力学[M].北京:机械工业出版社,2008.
Yu Fan,Lin Yi.Vehicle System Kinetics[M].Beijing:Mechanical Industry Press,2008.

[1]	XIN Liang1,2, DU Zixue1, YANG Zhen2, XU Zhouzhou2. Active Control of the Straddle-Type Monorail Vehicle with Single-Axle Bogie [J]. Journal of Chongqing Jiaotong University(Natural Science), 2021, 40(07): 123-127.
[2]	ZHANG Dongdong, ZONG Zichun, FENG Jinzhi. Multi-objective Optimization of Shift Law for Two-Gear AMT Based on NSGA-Ⅱ Algorithm [J]. Journal of Chongqing Jiaotong University(Natural Science), 2021, 40(07): 128-135.
[3]	LI Shengyong1, ZHANG Zhihua1, WANG Shengnan2, WANG Meng2. Defect Recognition Algorithm for Vehicle Metal Materials [J]. Journal of Chongqing Jiaotong University(Natural Science), 2021, 40(07): 136-144.
[4]	DU Zixue, WU Haoxin. Influence of Suspension Parameters on Air Gap Stability and Running Stability of Linear Motor Straddle Monorail Vehicle [J]. Journal of Chongqing Jiaotong University(Natural Science), 2021, 40(06): 124-129.
[5]	DENG Mingyang1,2，GUO Yingshi1. Interpolation Coupling Wireless Charging Technology for Electric Vehicles [J]. Journal of Chongqing Jiaotong University(Natural Science), 2021, 40(06): 130-135.
[6]	DU Zixue, MA Chuanxiang. Operation Stability Analysis of Articulated Straddle Monorail Train [J]. Journal of Chongqing Jiaotong University(Natural Science), 2021, 40(05): 122-128.
[7]	YU Man, ZHAO Weihua, WU Ling, LI Yuhan. Working Condition of Electric Vehicle Based on K-Mean Clustering and Support Vector Machine [J]. Journal of Chongqing Jiaotong University(Natural Science), 2021, 40(05): 129-139.
[8]	CAO Yuanwen1, CHEN Zuo1, ZHAO Jiang2, ZHANG Xiaoqiang3, ZHENG Tingting4. Driving Stability of Wheel Loader under Multiple Road Conditions [J]. Journal of Chongqing Jiaotong University(Natural Science), 2021, 40(05): 140-146.
[9]	DU Zixue, WU Haoxin, YANG Zhen. Curve Negotiation Performance of Linear Motor Straddle Monorail Vehicle [J]. Journal of Chongqing Jiaotong University(Natural Science), 2021, 40(04): 127-132.
[10]	DENG Tao1, LI Xin2. Combined Control Method of Intelligent Vehicle Longitudinal and Lateral Motion [J]. Journal of Chongqing Jiaotong University(Natural Science), 2021, 40(04): 133-140.
[11]	LI Yaohua, LIU Yang, SONG Weiping, SHAO Pandeng, REN Tianyuan. Components Durability Test Conditions Based on Driving Condition [J]. Journal of Chongqing Jiaotong University(Natural Science), 2021, 40(04): 141-146.
[12]	LIU Zhen1,3, LIN Xin1,2, WU Huawei1,3, YE Congjin1,3, GENG Xiangyang4. Design of IGBT Heat Dissipating Fin Structure Based on STAR-CCM+ [J]. Journal of Chongqing Jiaotong University(Natural Science), 2021, 40(03): 128-134.
[13]	LI Jun, ZHANG Jun, ZHANG Shiyi. Lithium Battery SOC Estimation Based on ABP-EKF Algorithm [J]. Journal of Chongqing Jiaotong University(Natural Science), 2021, 40(03): 135-140.
[14]	HAO Gang1, 2, JIN Tao1. Performance Degradation Assessment of Rolling Bearings Based on Hidden Markov Model [J]. Journal of Chongqing Jiaotong University(Natural Science), 2021, 40(02): 123-128.
[15]	LIU Chaotao, DI Kehong, DU Zixue, YANG Zhen. Active Control of Straddle Monorails Pantograph-Catenary Coupling [J]. Journal of Chongqing Jiaotong University(Natural Science), 2021, 40(02): 129-135.

Optimizing and Matching Analysis of Suspension Parameters of Van Truck Cab

厢式运输车驾驶室悬置参数的优化与匹配分析

PDF

Knowledge

Abstract

Cite this article

share this article

References

Related Articles 15

Recommended Articles

Metrics